Ets-lindgren 3816-2 LISN Bedienungsanleitung

Model 3816/2 Line Impedance Stabilization Network (LISN) User Manual

10 Maintenance www.ets-lindgren.com Service Procedures For the steps to return a system or system component to ETS-Lindgren for service, see the Pro

www.ets-lindgren.com Specifications 11 3.0 Specifications Electrical Specifications Frequency Range: 9 kHz–30 MHz (VDE 0876 specified curve ± 20%

12 Specifications www.ets-lindgren.com Environmental Installation: Indoor use only Altitude: 15000 ft (4572 m) max Temperature: 0°C to 40°C (32°F to

www.ets-lindgren.com Installation and Application 13 4.0 Installation and Application Before connecting any components, follow the safety informa

14 Installation and Application www.ets-lindgren.com The input power connection is made through a three-wire power cord utilizing the accepted inter

www.ets-lindgren.com Installation and Application 15 LINE SELECT SWITCH Select the line to be monitored by the three-position selector switch. The l

16 Installation and Application www.ets-lindgren.com Back Panel Connectors POWER INPUT The input power connection is made through a jacketed three-c

www.ets-lindgren.com Schematic 17 5.0 Schematic  Resistance values shown in ohms.  Ground choke select switch (S1) shown in the IN position.

18 Schematic www.ets-lindgren.com

www.ets-lindgren.com Warranty 19 Appendix A: Warranty See the Product Information Bulletin included with your shipment for the complete ETS-Lindgr

ii www.ets-lindgren.com ETS-Lindgren Inc. reserves the right to make changes to any product described herein in order to improve function, design, or

20 Warranty www.ets-lindgren.com This page intentionally left blank.

www.ets-lindgren.com EC Declaration of Conformity 21 Appendix B: EC Declaration of Conformity

www.ets-lindgren.com iii Table of Contents Notes, Cautions, and Warnings ... v 1.0 Introduction ...

iv www.ets-lindgren.com This page intentionally left blank.

www.ets-lindgren.com v Notes, Cautions, and Warnings Note: Denotes helpful information intended to provide tips for better use of the product. Caut

vi www.ets-lindgren.com This page intentionally left blank.

www.ets-lindgren.com Introduction 7 1.0 Introduction The ETS-Lindgren Model 3816/2 Line Impedance Stabilization Network (LISN) is a two-channel lo

8 Introduction www.ets-lindgren.com ETS-Lindgren Product Information Bulletin See the ETS-Lindgren Product Information Bulletin included with your s

www.ets-lindgren.com Maintenance 9 2.0 Maintenance Only trained service personnel should perform adjustments and/or service procedures. Inside t