ETS-Lindgren 3110C Bedienungsanleitung

Model 3110C Biconical Antenna User Manual

10 | Introduction This page intentionally left blank.

Maintenance | 11 2.0 Maintenance Before performing any maintenance, follow the safety information in the ETS-Lindgren Product Information Bull

12 | Maintenance Service Procedures For the steps to return a system or system component to ETS-Lindgren for service, see the Product Informat

Specifications | 13 3.0 Specifications Electrical Specifications Frequency Range: 30 MHz–300 MHz VSWR Ratio (Average): 2.0:1 Maximum Continuous

14 | Specifications MODEL 3110CP (WITH PORTABLE ELEMENTS) One element is shown for illustrative purposes only; all specifications are based

Assembly Instructions | 15 4.0 Assembly Instructions Before connecting any components, follow the safety information in the ETS-Lindgren Produ

16 | Assembly Instructions To assemble the Model 3110C: 1. Slide a belleville washer onto the threaded screw end of one of the biconical ele

Mounting Instructions | 17 5.0 Mounting Instructions Before connecting any components, follow the safety information in the ETS-Lindgren Produ

18 | Mounting Instructions To use these adapters to mount the Model 3110C to a 4-TR tripod: Shown mounted onto a 4-TR with clamp block, su

Mounting Instructions | 19 Using the Stinger Mount The stinger on the Model 3110C enables you to mount to antenna directly to an ETS-Lindgren 7-T

ii | ETS-Lindgren Inc. reserves the right to make changes to any product described herein in order to improve function, design, or for any other reas

20 | Mounting Instructions Additional Mounting Options 4-TR MOUNTING OPTIONS Following are additional options for mounting the Model 3110C ont

Mounting Instructions | 21 7-TR AND MAST MOUNTING OPTIONS The stinger on the Model 3110C enables you to mount the antenna directly to an ETS-Lind

22 | Mounting Instructions 2X2 BOOM MOUNTING OPTIONS Following are additional options for mounting the Model 3110C onto a 2x2 boom. Contact th

Application | 23 6.0 Application The Model 3110C Biconical Antenna is ideally suited for swept site attenuation measurements per ANSI and FCC sp

24 | Application This page intentionally left blank.

Typical Data | 25 7.0 Typical Data Antenna Factor

26 | Typical Data Gain

Typical Data | 27 VSWR

28 | Typical Data Half-Power Beamwidth

Warranty | 29 Appendix A: Warranty See the Product Information Bulletin included with your shipment for the complete ETS-Lindgren warranty fo

| iii Table of Contents Notes, Cautions, and Warnings ... v 1.0 Introduction ...

iv | This page intentionally left blank.

| v Notes, Cautions, and Warnings Note: Denotes helpful information intended to provide tips for better use of the product. Caution: Denotes a haza

vi | This page intentionally left blank.

Introduction | 7 1.0 Introduction The ETS-Lindgren Model 3110C Biconical Antenna is specifically designed for radiated emissions testing. This

8 | Introduction TRIPOD OPTIONS ETS-Lindgren offers the following nonmetallic, non-reflective tripods for use at both indoor and outdoor EMC t

Introduction | 9 ETS-Lindgren Product Information Bulletin See the ETS-Lindgren Product Information Bulletin included with your shipment for the